* Firmware Rev.1051 or later is required to access LiveWedge device settings menu. Please update your firmware if you are currently using firmware older than Rev.1051.
Use the jog wheel to select the cogwheel icon, then press [OK]
LANGUAGE
Change language.
INITIALIZE
Reset the LiveWedge unit to initial settings.
FIRMWARE
Display firmware version.
PROGRAM
Set the resolution of Program out. You can select [AUTO], [1080p60], [1080p50], [720p60], [720p50], [480p60] or [480p50].
PREVIEW 1
Set the resolution of Preview out. You can select [AUTO], [1080p60], [1080p50], [720p60], [720p50], [480p60] or [480p50].
PREVIEW 2
Choose any of the preview displays to display in an expanded format.
PREVIEW 3
Displays OSD (On Screen Display) information on the preview output. Available OSD information is below.
HDMI Inserted
- Input number (1 to 4)
- Resolution – E.g. if resolution is 1920×1080 interlaced – RESOLUTION: 1920x1080i
- Frame rate – E.g. if frame rate is 60 fps – FRAME RATE: 60
- Audio embed –
Embedded – AUDIO EMBEDDED: YES
Not embedded – AUDIO EMBEDDED: NO
HDMI Not Inserted
- Input number (1 to 4)
- Displays NONE as input
ETHERNET
Use DHCP mode or Apply IP mode.
Wi-Fi
Select the Wi-Fi mode, either [Client mode] or [AP mode].
Wi-Fi AP
Displays the Wi-Fi AP mode settings.
Wi-Fi Cli.
Displays the Wi-Fi Client mode settings.